Fault finder: GPIO on a Jetson
9 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
LED never lights: what should I check?
Check the pin number and that it is a GPIO pin on your model.
Permission error: what should I check?
Use the gpio group or sudo.
Button reads always low: what should I check?
Check the pull-up goes to 3.3 V, not 5 V.
