Fault finder: Remote control code reader

6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing prints: what should I check?

Check pin order, the dome faces you and OUT is on the left.

Always unknown: what should I check?

Try another remote or move closer.

Codes change each press: what should I check?

Some remotes use a rolling code, use another.

Compile error on IrReceiver: what should I check?

Install IRremote version 4 or later.

Noisy prints: what should I check?

Bright lamps nearby can interfere, shade the receiver.