Fault finder: TV remote code reader

8 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing printed: what should I check?

Check the receiver's pin order and that OUT is on D2. Try another remote.

Protocol=UNKNOWN: what should I check?

Some AC remotes send long frames. Use printIRResultRawFormatted to see them.

Gets warm: what should I check?

VCC and GND are swapped. Unplug at once.