Fault finder: TV remote relay switch

8 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No codes appear: what should I check?

Check OUT is on D11, and point the remote straight at the dome from under 3 m.

Relay switches on boot or works inverted: what should I check?

Many modules are active LOW: swap HIGH and LOW in the code.

Board resets when the relay clicks: what should I check?

Power the relay module from a separate 5 V supply with a shared GND.