Projects / Infrared data link / Fault finder

Fault finder: Infrared data link

6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing received: what should I check?

Check the receiver pins and that the LED faces it.

Garbage characters: what should I check?

Weak signal. Move closer or lower the resistor value.

Camera shows no flash: what should I check?

LED is backwards or the sender is not running.

Works only very close: what should I check?

Use a lower resistor value and align the LED and receiver.