Fault finder: Interrupts lab
9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Both counts stay zero: what should I check?
Check the 555 output and wires to D2 and D4.
Interrupt count too high: what should I check?
Check there is no bounce or noise on the pin.
Display flickers: what should I check?
Normal while busy; it refreshes every 200 ms.
Counts jump oddly: what should I check?
Read the volatile variable with interrupts off.
