Fault finder: I2C bus with three sensors

10 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Scanner finds nothing: what should I check?

Check SDA on A4, SCL on A5 and the power pins.

BME280 not found: what should I check?

Try the other address or check its VCC level.

OLED blank: what should I check?

Check 0x3C appears in the scan and the display wiring.

Values freeze: what should I check?

A loose wire has stopped the bus. Check all joints.