Fault finder: I2C scanner and address map lab

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No devices found: what should I check?

Check SDA and SCL are not swapped and the module has power.

Every address responds: what should I check?

A device is holding the bus low, remove modules one by one.

Address not in my list: what should I check?

Look at the module datasheet, the list is only a guide.

Intermittent results: what should I check?

Shorten wires, check for loose breadboard contacts.

3.3 V module misbehaves: what should I check?

Check its voltage and use a level shifter on a 5 V board.