Fault finder: I²C address explorer

10 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

0 devices: what should I check?

Swapped lines, missing ground, or a 5 V-only module.

Every address found: what should I check?

SDA or SCL shorted to ground.

Unknown address: what should I check?

Search the module's chip name; many have an address pin.