Fault finder: NFT hydroponics pump and water level guard

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Pump runs when the reservoir is low: what should I check?

The float logic is the wrong way. Flip it.

Timer shows odd values: what should I check?

Use unsigned long for all times.

No display: what should I check?

Check the LCD address and wiring.

Relay never clicks: what should I check?

Active-low versus active-high mismatch. Swap the HIGH and LOW writes.