Fault finder: Colour and object sorter with HuskyLens

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

HuskyLens not found: what should I check?

Wrong protocol setting, or SDA and SCL swapped.

Arm twitches or Uno resets: what should I check?

Servo power; use a separate 5 V supply with shared GND.

Wrong object chosen: what should I check?

Teach it again from several angles in the same light.

Servo does not move: what should I check?

Check D9 and the object IDs learned.

Compile error: what should I check?

Install the HUSKYLENS library.