Fault finder: Humidity display with OLED

11 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always "Sensor error: what should I check?

Check the pull-up and that you read no faster than every 2 s.

OLED blank: what should I check?

Run an I2C scanner: the address may be 0x3D.

Humidity stuck at 99 %: what should I check?

Condensation: let the sensor dry out.