Fault finder: Humidity sensor calibration with salts
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Readings keep drifting: what should I check?
Wait longer and keep the jar still.
Wild difference: what should I check?
Check the sensor is not touching the liquid.
Jar reads lower: what should I check?
Add a little water and make sure salt remains.
