Fault finder: Animated eight-by-eight faces

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing lights: what should I check?

Check VCC, GND and that SDA and SCL are on A4 and A5.

Display stays blank after upload: what should I check?

Scan the I2C address, it may not be 0x70.

Picture is mirrored: what should I check?

Try the other setRotation values.

Compile error about the library: what should I check?

Install both Adafruit libraries.

Button changes speed twice: what should I check?

Keep the 30 ms delay after a press.