Fault finder: Hot-wire foam cutter

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Wire barely warms: what should I check?

Raise the current limit or use a shorter wire.

Foam smokes heavily: what should I check?

Too hot; lower the current.

Cut is rough: what should I check?

Move slower, keep the wire straight with the spring.