Fault finder: Room presence sensor that sees people sitting still

11 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Never detects: what should I check?

Check TX and RX are crossed and the baud rate is 256000.

Detects through walls: what should I check?

Reduce the maximum range gate.

False triggers: what should I check?

Lower the gate sensitivity and move the sensor.

Relay logic reversed: what should I check?

Swap HIGH and LOW for your board.