Fault finder: ESPHome sensors in Home Assistant

10 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

BME280 not found: what should I check?

Try address 0x77 and check SDA and SCL wires.

Device does not appear in Home Assistant: what should I check?

It is on a different network or the API is blocked. Check Wi-Fi and the logs.

PIR always on: what should I check?

Its sensitivity and time pots are set high. Turn them down and give it a minute to settle.

Compile error: what should I check?

ESPHome version differs. Update it and check the ota syntax.