Fault finder: Heart rate monitor with OLED

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

MAX30102 not found: what should I check?

Check SDA/SCL and 3V3. Some boards need the 3.3 V / 1.8 V jumper set to 3.3 V.

Numbers jump around: what should I check?

Press more lightly and keep still. Movement and room light disturb the signal.

Not a medical device: what should I check?

This shows how pulse sensing works. Never use it to make health decisions.