Fault finder: Address decoder with eight LEDs

9 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Two LEDs lit: what should I check?

A button input is floating, check the pull-down.

No LED lit: what should I check?

Check the enable pins and the LED direction.

LEDs very dim: what should I check?

Normal with CMOS outputs, keep 1 kilohm.

Wrong LED for a code: what should I check?

Check the pin order of the outputs.

Chip warm: what should I check?

Check the supply is 5 V, not more.