Fault finder: Fruit ripeness colour checker

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Readings change with daylight: what should I check?

Close the tube so only the LED lights the fruit.

Wrong grades: what should I check?

Recalibrate the thresholds from your own fruit.

Sensor not found: what should I check?

Check I2C wiring and the 0x29 address.

LED stays off: what should I check?

Check the resistor and the pin numbers.