Fault finder: Hand-raise light board

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

A desk does nothing: what should I check?

Check its button goes to its pin and to GND.

LED stays dark: what should I check?

Check its direction and the 220 ohm resistor.

No beep: what should I check?

Check you have a passive buzzer on A1.

Lights stay on after clear: what should I check?

Check the clear button goes to D8.

Serial monitor shows nothing: what should I check?

Open it at 9600 baud.