Fault finder: Hall sensor door position logger

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always OPEN: what should I check?

Magnet too far or facing the wrong pole. Flip it over.

Flickers between states: what should I check?

Widen the gap between the thresholds.

No log file: what should I check?

Check the SD card is FAT32 and the wiring on D10 to D13.

Time is wrong: what should I check?

Set the DS3231 with the example sketch and check its battery.