Projects / Half and full adder / Fault finder

Fault finder: Half and full adder

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LEDs show wrong values: what should I check?

Check each gate's input and output pin numbers carefully. It is easy to shift by one.

LEDs flicker: what should I check?

An unused input is floating. Tie it to GND.

One input has no effect: what should I check?

The DIP switch contact is bad or its pull-down is missing.

Chips get warm: what should I check?

A pin 14 and pin 7 are swapped or an output is shorted to another.