Fault finder: SMS-controlled relay

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Module does not answer AT: what should I check?

Check the supply voltage, the capacitor and the TX/RX wires.

Resets when sending: what should I check?

Supply cannot give the burst current. Use a larger capacitor and a better buck module.

No network: what should I check?

Check the SIM, antenna and signal with AT+CSQ.

Relay is inverted: what should I check?

Swap the HIGH and LOW writes for your relay type.