Fault finder: Grain storage temperature and moisture probe
8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
A probe reads -127: what should I check?
Check its wiring and the shared pull-up.
Only two probes found: what should I check?
Check each data wire joins the bus.
No display: what should I check?
Try LCD address 0x3F.
False warnings: what should I check?
Probes in different sun or draught; keep them in the same bin.
