Fault finder: GPS speedometer and location display

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No data: check TX wire: what should I check?

GPS TX must go to GPIO16. Check the module LED is on.

Never gets a fix: what should I check?

Go fully outdoors and wait 5 minutes. A cold start needs open sky.

Speed jumps while still: what should I check?

Show 0 when the speed is below 2 km/h.

Safety: what should I check?

Never look at the screen while riding or driving.