Projects / Toy track lap timer / Fault finder

Fault finder: Toy track lap timer

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Never triggers: what should I check?

Turn the sensitivity screw and check the OUT wire.

Triggers constantly: what should I check?

Aim away from reflective surfaces and lower the sensitivity.

Display blank: what should I check?

Check CLK and DIO and the library.

Times look doubled: what should I check?

Two triggers per lap, raise MIN_LAP_MS.

Wrong decimal point: what should I check?

Change the 0b01000000 colon mask for your display.