Fault finder: Hand gesture controlled robot

12 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No radio link: what should I check?

Check the 10 uF capacitors and the address.

Wrong direction: what should I check?

Swap the motor wires or the tilt signs.

Jerky: what should I check?

Lower the send rate or the dead zone.