Projects / Frequency counter / Fault finder

Fault finder: Frequency counter

5 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Readings jump about with nothing connected: what should I check?

A floating input picks up noise. Connect the signal ground and use a short lead.

Reads half the frequency or double: what should I check?

Check you chained two inverters, not one, and that the generator output is a square wave of 3 V or more.

Always 0 Hz: what should I check?

Check the signal goes to D5, not D4, and the 74HC14 has power on pins 14 and 7.

Never exceed 5 V: what should I check?

For higher voltages use a divider first, or you can damage the chip.