Fault finder: Hands-free workbench timer

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Blank screen: what should I check?

Check A4 and A5, and try address 0x3D in the sketch.

Pedal acts twice: what should I check?

Increase the DEBOUNCE value a little.

Pedal does nothing: what should I check?

Check the wires reach D2 and GND, some pedals are normally closed.

Stop never happens: what should I check?

Hold the pedal for a full second without releasing.

No sound: what should I check?

Check the buzzer is a passive type on D8.