Fault finder: Digital FM radio with TEA5767

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LCD blank: what should I check?

Wrong address. Try 0x3F or run an I2C scanner, and adjust the contrast trimmer.

Only noise: what should I check?

The antenna is missing or too short. Use a longer wire.

Frequency off by about 0.2 MHz: what should I check?

The module uses a different crystal. Check the data byte 0x10 against your module.

Hum in the speaker: what should I check?

Power the amplifier from a separate supply or add a 100 µF capacitor.