Fault finder: Build a latch from NAND gates

9 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Both LEDs always off: what should I check?

Check pin 14 and pin 7 and the LED direction.

Latch does not hold: what should I check?

Check the cross wires pin 3 to 5 and pin 6 to 2.

Buttons do nothing: what should I check?

Check the pull-ups and that buttons go to GND.

LEDs dim: what should I check?

Check 330 ohm resistors and a good 5 V supply.

Random flips: what should I check?

A floating input, tie unused pins to GND.