Fault finder: Self-blinking LED lab

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Never flashes: what should I check?

Check the LED direction and that the meter is on the mA range.

LED very dim: what should I check?

The pot resistance is too high.

Meter shows 0: what should I check?

Check the fuse and the red probe jack for current.

Constant light only: what should I check?

The part may be a plain LED, check the packet.

LED hot: what should I check?

Turn the pot down only to the 330 ohm minimum, never remove the resistor.