Fault finder: Fingerprint door lock

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Sensor not found: what should I check?

TX and RX swapped, or the module runs at a different speed. Try finger.begin(9600).

Enrolled finger often refused: what should I check?

Re-enrol with the finger flat and centred, and keep the glass clean.

Lock chatters: what should I check?

Check the flyback diode and use a 12 V adapter rated 2 A.

Privacy: what should I check?

Prints are stored inside the sensor, not on the Uno. Delete them with the "delete" example before giving the sensor away.