Fault finder: Feedback smiley button box

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Counts jump: what should I check?

Check the button wires and the common ground.

Counts do not stay: what should I check?

Check the sketch saves to EEPROM and that you have not reset it.

Display blank: what should I check?

Check the OLED address 0x3C and the I2C wires.

Two counts per press: what should I check?

Press and release cleanly, or lengthen the 250 ms wait.

Strange numbers at first: what should I check?

Clear the counts once with the two-button hold.