Fault finder: Shift register fault hunt
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No LED lights: what should I check?
Check pin 16 to 5V, pin 8 to GND and pin 13 to GND.
All LEDs stay lit dimly: what should I check?
Pin 13 may be floating.
Pattern shifts by one: what should I check?
Check the clock and latch wires.
Chip gets warm: what should I check?
Check the 330 ohm resistors are in line.
LED never lights: what should I check?
Check its leg direction.
