Fault finder: Resetting board fault hunt

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Servo does nothing with the pack: what should I check?

The grounds are not joined.

Board still resets: what should I check?

Check the pack plus goes only to the servo, and the cells are fresh.

Rail reading looks wrong: what should I check?

The reading is only a guide, use the meter for a check.

Servo buzzes at the ends: what should I check?

Stop at 20 and 160 degrees as in the sketch.

Serial text garbled: what should I check?

Set 9600 baud.