Fault finder: Blank OLED fault hunt

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing found with correct wiring: what should I check?

Check the pins A4 and A5 and the power at the module.

Found at 0x3D: what should I check?

The sketch picks the address it finds, so it still works.

Display starts then garbles: what should I check?

The screen size or the controller type may differ.

Device found but blank: what should I check?

Check the library and the screen size in the sketch.

Compile errors: what should I check?

Install both libraries.