Fault finder: Button and LED wiring fault hunt
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Nothing prints: what should I check?
Set 9600 baud in the serial monitor.
Upload fails: what should I check?
Choose the Old Bootloader option and the right port.
LED always on: what should I check?
Check the LED wire is not on 5V.
Monitor always 0: what should I check?
The button leg may be shorted to ground.
Wires keep falling out: what should I check?
Push them in firmly.
