Fault finder: Dark flasher fault hunt

8 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

The LED never blinks even when built as drawn: what should I check?

Check pin 1 to ground and pin 8 to plus first.

Half the 555 pins are not powered: what should I check?

Count the pins from the notch, pin 1 is just left of it.

Blinks too fast to see: what should I check?

Use a larger timing capacitor.

Battery reading is low: what should I check?

Replace the 9 V battery.

Capacitor looks hot: what should I check?

Disconnect and check its stripe is on the minus side.