Fault finder: Screen break reminder
6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Never detects: what should I check?
The radar needs a few seconds to start and 5 V supply. Check OUT is wired to D2.
Detects an empty chair: what should I check?
The radar sees moving fans or curtains. Reduce range with the LD2410 phone app or aim away.
Ring shows odd colours: what should I check?
Check DIN is on D6 and that the colour order is GRB.
Ring resets the Nano: what should I check?
Too bright. Keep brightness at about 30 and use a good USB supply.
