Fault finder: Wired Ethernet sensor node
9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No DHCP: what should I check?
Check the cable and the module power.
Page does not open: what should I check?
Check the IP address and the firewall.
Reboots: what should I check?
Give the module a stable supply.
MQTT fails: what should I check?
Check the broker address and port.
