Fault finder: ESPHome smart switch for a 12 V load

10 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Relay clicks at boot: what should I check?

Remove or add the inverted line.

Not found in Home Assistant: what should I check?

Check the api key and that both are on one network.

Flash over USB fails: what should I check?

Hold the board in flash mode or try another cable.