Fault finder: ESP32 touch pin foil buttons

7 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Touches missed: what should I check?

Raise the threshold fraction, or press more firmly on the foil.

Lights change by themselves: what should I check?

Lower the threshold fraction and keep wires short and still.

Idle value is very low: what should I check?

The wire may be touching something, so check it.

LED stays off: what should I check?

Check the LED direction and the resistor.

Does not boot after wiring: what should I check?

Unplug anything on GPIO2, GPIO12 or GPIO15.