Fault finder: ESP32 Wi-Fi network lister

11 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Blank screen: what should I check?

Check the OLED address 0x3C and the GPIO21 and GPIO22 wires.

No networks listed: what should I check?

Move closer to a router and check the antenna is clear.

Compile error: what should I check?

Install the Adafruit libraries and select ESP32 Dev Module.

Names cut off: what should I check?

The display shows only 14 characters.

Upload fails: what should I check?

Hold BOOT during the upload.