Fault finder: ESP32 sun exposure meter

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always zero: what should I check?

Check OUT is on GPIO34 and the module has 3.3 V.

Always at the maximum: what should I check?

The output may be above 3.3 V, check your module's supply.

Reading differs from a weather app: what should I check?

This is a rough guide, the sensor and the official index use different light bands.

Display blank: what should I check?

Check the I2C wires and the address 0x3C.

Readings noisy: what should I check?

Keep the wires short and away from the display wires.