Fault finder: ESP32 expansion board first test

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Port does not appear: what should I check?

Try another USB cable and install the CH340 or CP210x driver.

Upload fails: what should I check?

Hold BOOT while it connects.

LED never lights: what should I check?

Check the leg direction and that the wire is in the S terminal of GPIO23.

Count jumps: what should I check?

Check the button wiring and the common ground.

Board is hot: what should I check?

Unplug, check no terminal is shorted and the board is seated correctly.