Fault finder: ESP32 DevKit V1 visitor counter

12 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Counts by itself: what should I check?

Wait the full 30 seconds, and keep the PIR away from heaters and sunlight.

Never counts: what should I check?

Check PIR OUT is on GPIO27 and the PIR has 5 V on VIN.

Count not saved: what should I check?

Check the sketch has the Preferences lines.

Display blank: what should I check?

Check the I2C wires and the address 0x3C.

Board will not upload: what should I check?

Install the CH340 driver and hold BOOT while uploading.