Fault finder: ESP32 DevKit V1 encoder dimmer

7 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Goes the wrong way: what should I check?

Swap the CLK and DT wires.

Skips or jumps: what should I check?

Check the encoder is on 3.3 V and the wires are firm.

LED never lights: what should I check?

Check the leg direction and that the resistor is on GPIO18.

Does not compile: what should I check?

Choose the ESP32 Dev Module board and the esp32 package.

Press does nothing: what should I check?

Check SW is on GPIO25 and GND is connected.