Projects / ESP32-C3 RPM meter / Fault finder

Fault finder: ESP32-C3 RPM meter

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always zero: what should I check?

Check DO is on GPIO4, the sensor distance and the dial setting.

Reading is double: what should I check?

Reflections from the shaft end, add a black cover or set MARKS to match.

Reading jumps: what should I check?

Shield the sensor from bright light, and keep it steady.

Display blank: what should I check?

Check the OLED address 0x3C and the I2C wires.

Motor makes noise on the reading: what should I check?

Keep the sensor leads away from the motor leads.